Page 1 of 1
Primary productivity products no longer available from l2gen?
Posted: Thu May 24, 2018 1:01 pm America/New_York
by dbotis
Hi
In looking at SD7.5 l2gen, I don't see the primary productivity products (e.g. opp_cbpm2) listed as potential outputs. Did they get renamed? Am I looking in the wrong place? Thanks,
Dan
Primary productivity products no longer available from l2gen?
Posted: Thu May 24, 2018 2:26 pm America/New_York
by OB.DAAC-EDL - SeanBailey
Yes, they are now npp_*
Primary productivity products no longer available from l2gen?
Posted: Thu May 24, 2018 2:28 pm America/New_York
by OB SeaDAS - dshea
We changed the name from opp to npp since that is how it is referenced in Behrenfeld's papers.
don
Primary productivity products no longer available from l2gen?
Posted: Thu May 24, 2018 3:03 pm America/New_York
by dbotis
Thanks, Don
One other question. I now see that "adg_giop" is an option for output with no wavelength designation. Is this at 443nm? I have l2gen running now outputting "adg_443_giop" and it's running fine. I'm just curious about the IOPs and if the names of potential outputs have changed there too.
Dan
Primary productivity products no longer available from l2gen?
Posted: Fri May 25, 2018 8:05 am America/New_York
by OB SeaDAS - knowles
There is no product of l2gen called "adg_giop" without a wavelength designation. There is a folder called "adg_giop" in the l2gen GUI, but if you open it up you will see that all entries require a wavelength. The checkbox on the folder behaves as a three-way toggle (none, partial and all) - where partial is tied to the "Wavelength Limiter".
Danny