Page 1 of 1

Sentinel-2 A & B

Posted: Tue Apr 05, 2022 3:09 pm America/New_York
by avmehta
I have a couple of questions about l2gen options for processing MSI data from Sentinel 2A and 2B.

In the output messages I see the following statements (not sure why it says it is an OLCI file!):
" Found Sentinel-2A product: SENTINEL-2 MSI Level-1C User Product
Input file is an OLCI file."

Loading user parameters for MSIS2A
Internal data compression requested at compression level: 4
Reading Thuillier_F0.dat
Input file: MSI Level-1C
proj_create_operation_factory_context: Cannot find proj.db
pj_obj_create: Cannot find proj.db
pj_obj_create: Cannot find proj.db

1) Is there a recommendation for what to use for aer_opt? I have used aer_opt=-2.
I get the following error if I use aer_opt=-9:
Aerosol selection bands 865 and 1613
Aerosol selection bands -1 and -1 not available for this sensor

Error: latBand.getProduct().getSceneRasterWidth() < 2 ||
latBand.getProduct().getSceneRasterHeight() < 2
2) Based on some information I saw in the Forum I use the following for Sentinel2A processing
Is this OK? So for Sentinel-2B should I use 2164 for cloud_wave?
3) Are there any suggestions for the following?
aer_wave_short, aer_wave_long
aer_swir_short, aer_swir_long

Thank you for your help.


Re: Sentinel-2 A & B

Posted: Thu Jul 07, 2022 1:40 pm America/New_York
by ASDC - ingridgs
Hello user,
In order to re-direct your question to the correct center and expert, can you please let us know where did you obtain the datasets and the long name of the datasets you are having questions with?

Thank you,