I want to convert the MOBY (in situ buoy data) water leaving radiance () to remote sensing reflectance.
The data can be seen on the website: https://www.star.nesdis.noaa.gov/socd/moby/filtered_spec/M272_2022052323d.txt.
The following is the information given in the text file.
" DscS 1: MOS Calibrated Wavelength (nm)
DscS 2: Water-Leaving Radiance Lw1, Lu1 and Kl1(Lu1-Lu2) (�W/cm�/sr/nm)
DscS 3: Water-Leaving Radiance Lw2, Lu1 and Kl2(Lu1-Lu3) (�W/cm�/sr/nm)
DscS 4: Water-Leaving Radiance Lw7, Lu2 and Kl3(Lu2-Lu3) (�W/cm�/sr/nm)
DscS 5: Surface Irradiance (�W/cm�/nm) for Lw1
DscS 6: Surface Irradiance (�W/cm�/nm) for Lw2
DscS 7: Surface Irradiance (�W/cm�/nm) for Lw7
DscS 8: Modeled KL: Water-Leaving Radiance Lw21, Lu1 and Kl21-m (�W/cm�/sr/nm)
lambda, Lw1, Lw2, Lw7, Ed Sfc, Ed Sfc, Ed Sfc, Lw21
343.8885, 1.158202, , , 78.828, 78.828, 81.033, 1.158202
344.4570, 0.824319, , , 68.706, 68.706, 71.467, 0.824319
Is there any way to convert the Lw values into Rrs (unit /Sr)? My plan is to compare the Hawaii time series Rrs (Sr^-1) (MOBY) with SeaHawk L2 Rrs (Sr^-1)?
Can I get the Rrs (Sr^-1) by the following equation?
Rrs = Lw1/Ed Sfc [As this is an insitu mesurement]
I found this site (https://seadas.gsfc.nasa.gov/help-8.2.0/rad2refl/Rad2ReflAlgorithmSpecification.html#:~:text=The%20conversion%20from%20TOA%20radiance,the%20inverse%20of%20this%20equation.) But, I am not sure if it is applicable for the buoy data.
Any help will be highly appreciated.
- Subject Matter Expert
- Posts: 65
- Joined: Fri Jun 03, 2022 10:54 am America/New_York
- Location: NASA GSFC
- Been thanked: 1 time
I'm not very sure about NOAA data, but for the MOBY data provided through SeaBASS, here is a documentation with all the details: https://seabass.gsfc.nasa.gov/wiki/MOBY
Hope it helps.