Page 1 of 1
Open Source VIIRS processing Software?
Posted: Fri Jul 19, 2024 6:00 pm America/New_York
by nprestine
Is there an open source release of the software used to created VIIRS level 2 data? Software that takes in level 1 data and outputs ex: VIIRS level 2 cldprop data?
Re: Open Source VIIRS processing Software?
Posted: Mon Jul 22, 2024 10:00 am America/New_York
by LAADS-EDL_UserServices_M
No, there is no open source release of the software used to created VIIRS level 2 data. However, in some case users can request for the software following steps and instruction provided at:
https://modaps.modaps.eosdis.nasa.gov/services/pge/
Re: Open Source VIIRS processing Software?
Posted: Mon Jul 22, 2024 1:04 pm America/New_York
by nprestine
I was able to get access, however, I am not seeing the CLDPROP algorithm code on the site. Looking for code on this algo "CLDPROP_L2_VIIRS_SNPP - VIIRS/SNPP Cloud Properties L2 6-Min Swath 750 m"
https://ladsweb.modaps.eosdis.nasa.gov/missions-and-measurements/products/CLDPROP_L2_VIIRS_SNPP#overview
Any insight on this?
Re: Open Source VIIRS processing Software?
Posted: Wed Jul 24, 2024 8:09 am America/New_York
by LAADS-EDL_UserServices_M
Information is provided in response to your other message.